18650 Li-ion akkumulátorvédelmi töltőpanel BMS-PCB tábla 2S 3A
A felülvizsgálat egy részét automatikusan lefordították.
A simple little protection board for low current (3A or less draw) systems using 2 series lithium cells. The type / size of cell is not important but the chemistry, must be lithium. The Negative ( -) end of the first cell is connected to the PCB terminal marked B- The connections between the (+) positive end of the first cell and the (-) Negative end of the second cell is connected to the PCB terminal marked BM (battery middle?) The (+) Positive end of the second cell is connected to the PCB terminal marked B+ The connection to the load / charge is made to the terminals marked P+ (7.5V nominal) and P- (GND Negative) Operation is simple. If either of the 2 series cells exceeds the upper voltage limit or drops below the lower voltage limit, the load / charge connection disconnects. The load / charge connection reconnects when the voltages are normal again. This may be the basis of a simple charge limiting circuit and over discharge protection circuit. The board is well made and works as it should. I hope this clears up some of the questions raised.
Nabíjací a ochranný obvod pre 2ks spojené Li ion batérie 18650 2S 7,4 V. Balenie po 5 ks.
Gyorsan megérkezett
nagyon jó ajánlom 🤝🏿
vásárolt, hogy megvédje a külső akkumulátorok őket ion külső modul r9m. A forrasztani kívánt párnák finomak. 385°-nál leválnak és mozognak.
Gyors szállítás. Jól működik
good quality, it's working, very small dimensions
érkezett nagyon gyorsan még nem próbálja meg, de jól néz ki, amikor kipróbálom, fogok megjegyzést több
nice and small
Nagyon jó.