3 darab 1M PTFE Bowden cső a Reprap 3D nyomtatóhoz 1.75 mm-es filamenttel
A felülvizsgálat egy részét automatikusan lefordították.
Parfait pour déporter le moteur d'un extrudeur.
correspond au déscriptif
the PTFE tube itself is fine, comes with 2 push fit ends aprox m10 thread. so glad I also ordered some m5 push ends. where i was disappointed was the packing, it comes coiled to a diameter of aprox 100mm which is bad enough, but then the ends were wrapped through the coil , causing the whole length to take a spiral form, the worst of which suspending with a weight on the end for a day or 2 managed to remove. so usable but a bit kinky
Az előírások szerint
kiváló minőségű, azt kaptam, amit vártam, de úgy gondolom, hogy egy olyan személy, mint én, akinek csak 2 nyomtatója van, sok pótalkatrész, de soha nem túl sok. excelente kalidad, recibi lo que esperaba, bűn embargo kreo para una como vo tengo szóló 2 impresoras es szolyo repuesto, pero nucca esta demas.
Csak túl hosszú, de rendben
very Good
Gyors szállítás
As described...
Megvan, de még ne használd.