5 db ANENG SMD chip komponens LCR tesztelő eszköz Multiméter toll csipesz
A felülvizsgálat egy részét automatikusan lefordították.
With my new probes, measuring SMD compassants becomes easier, but it takes hands and therefore no photos. This clamp is well made because I can easily measure on a finished circuit to control a component, or even easier to I sort out the components placed on a work surface and start searching for the desired SMD. The measurement is easier, I have one hand left to take the photos for proof! Only one small drawback, the clamp is hard to tighten the end on the SMD. After a quarter of an hour ... the cramp. By slightly bending the final electrodes of the clamp, you're done ... But with pressure when tightening when measuring. Perfect here photos with an SMD resistor marked 103 or 10Kohms. I tested one at a friend's house, I quickly understood the interest in I bought 5 in total!
ok
très bon produit
Good value for the price, they would benefit from a sharper point to break through the oxide layer.
Megkapta ezt a sorrendben, és kipróbáltam, és jól néz ki, és remekül működik. Köszönöm Fabio
Rendben