I bought these for my FrSky D4R-II receivers. The tubes are quite short, they could do with another 3cm length. I just let the aerial wires hang out the top though. The adhesive pad is pretty strong, I used it in conjunction with tie-wraps though; there are holes back and front to put tie-wraps right through. I'd definitely buy more of these despite the short tubes. They're very compact and I prefer them to the usual 3D printed versions.

I bought these for my FrSky D4R-II receivers. The tubes are quite short, they could do with another 3cm length. I just let the aerial wires hang out the top though. The adhesive pad is pretty strong, I used it in conjunction with tie-wraps though; there are holes back and front to put tie-wraps right through. I'd definitely buy more of these despite the short tubes. They're very compact and I prefer them to the usual 3D printed versions.

I bought these for my FrSky D4R-II receivers. The tubes are quite short, they could do with another 3cm length. I just let the aerial wires hang out the top though. The adhesive pad is pretty strong, I used it in conjunction with tie-wraps though; there are holes back and front to put tie-wraps right through. I'd definitely buy more of these despite the short tubes. They're very compact and I prefer them to the usual 3D printed versions.

Jó antenna szívószálak nem Nedd a tartó, mint én betűtípus van, hogy a keret még egy olcsó ár lehet kapni két antenna szívószál, hogy tökéletesen illeszkedik az én 3d nyomtatott tartó az én fpv Drone, mivel ezek szabványos méretű. Még nem repültem velük, biztos vagyok benne, hogy tökéletesen megvédik az RX erősítőket.

Good antenna straws didn't Nedd the holder as I font have that frame yet for a cheap price you can get two antenna straws that fit perfectly in my 3d printed holder on my fpv Drone as they are standard size. haven't flown with them yet I'm sure they will protect the rx antennas perfectly well.

Jó antenna szívószálak nem Nedd a tartó, mint én betűtípus van, hogy a keret még egy olcsó ár lehet kapni két antenna szívószál, hogy tökéletesen illeszkedik az én 3d nyomtatott tartó az én fpv Drone, mivel ezek szabványos méretű. Még nem repültem velük, biztos vagyok benne, hogy tökéletesen megvédik az RX erősítőket.