ESP32S ESP32 0.5A micro USB töltőpanel 18650 akkumulátor töltő pajzs akkumulátor nélkül
A felülvizsgálat egy részét automatikusan lefordították.
Gyors szállítás, nagyon praktikus és olcsó, 100% ajánlott munka 100% talán rendelni azokat, amelyek több akkumulátor, nagyon praktikus
I bought 5 pieces, tested them, worked well, removed the correct tensions at a load of 1 A, we did not test them at a load higher than 1 A.
Best for ardunio boards and mobile charging Output voltage 5V and amper not measured but it is approximately 1amp. built quality is also excellent.
Jó, két munkást vittem el. Küldés után volt szükség, hogy aktiválja- tápellátás, mikro USB, majd elkezdte adni a terhelés- 3.3 v., 5 v. és USB kimenet. A kapcsoló az USB kimenet gyenge, jobb, ha rövidre.
3 Pieces, Packaged well. All Works unexpected. (DOA) Do not charge (attaching to charges - charger goes to ovearload protection mod - switches off) it' s due to chortened chargeing circuit (~ 0,09 Omh between (+) and (-) pins on micro USB Do not converts properly: * Must 3V , Actually 1,264 V; * Must 5V, actually 1.186V
Nice product that I use as power reserve for Arduino or ESP32 projects. The only drawback is the mechanical strength of the mini USB plug (not related to the product manufacturing but the plug itself), so I put some epoxy glue around the mini USB plug to strengthen it.
使えませんでした。 手持ちの18650バッテリは保護回路があり、長さが約69mm。 この製品の端子はマイナス側も板バネだったので、電池入らず。 「長めの18650は使えない」との説明が欲しかった。 写真の電池ボックスのように、マイナス側がコイル状の端子なら使えるのに・・・。
Great battery charger /supply for arduino. Battery not incl.
you would need to purchase a 18650 Li battery, insert it, and you have a great UPS for your projects. it has 3.3 and 5V output, the 5V is 1.7A, and not 4.... but it okay. You have to detach the load, if you over discharge the battery, otherwise the charging process will be not started!
Jól felszerelt, és a kijárati és belépési irányokkal, minden jónak tűnik.