L9110S H híd léptetőmotor kettős DC meghajtó vezérlő modul
A felülvizsgálat egy részét automatikusan lefordították.
Despite the small difference in appearance, the device is as as described. Everything works normally. Only problem I had when supplied with 12.14 volts. Although LEDs lit, no output voltage. I suppose that the maximum supply voltage is a little less than 12 volts.
Used for Arduino projects - just search for "Arduino L9110S" on Google, and you will find Lib and examples. Even with a "short" on the motor side, I have not been able to "Kill" the board
a csomagon javítani kell. Néhány tű pli
Pretty nice
Szép és kicsi tábla. Minden rendben van az én DY OTO Robot!
Minden jó
Jó
jó sorrendben érkezett
Tested with a pro mini and worked great. I had to try two different power plug supply's, one was 12.3 volts even though it was labeled as 12 volts and it did not work. It did not damage it but be careful it might. 12 volts might be its absolute max. I will probably use this with a 9 volts just to be safe
Just be sure that you check the connections to match them with your circuit. (Vcc, GND, A1A, A1B,etc.) The connecting pins are in a different order than the ones on the controller shown in the diagrams in my project. Not a problem; the controller will work fine when you connect the wires correctly according to the labels printed on the board.