One of the lead screws is a little bent and the z motor struggles to take the heated bed up, the mainboard fan is bigger then the mainboard mount and doesn't fit and the auto level sensor doesn't trigger when the heated bed comes near.

One of the lead screws is a little bent and the z motor struggles to take the heated bed up, the mainboard fan is bigger then the mainboard mount and doesn't fit and the auto level sensor doesn't trigger when the heated bed comes near.

One of the lead screws is a little bent and the z motor struggles to take the heated bed up, the mainboard fan is bigger then the mainboard mount and doesn't fit and the auto level sensor doesn't trigger when the heated bed comes near.

Nagyon jó termék. Teljes nyomtató. Azt mondja, hogy nem tartalmazott néhány érzékelőt, de az összes benne volt, Futtatás Fiament és Auto-Leveling. A nyomtatott kézikönyvben van néhány hiba. De a digitális helyes. Jó termék.

Very good product. Complete printer. It says that it was not included some sensors, but there were all included, Run Out Filament and Auto-Leveling. The printed manual has some mistakes. But the digital one is correct. Good Product.

Nagyon jó termék. Teljes nyomtató. Azt mondja, hogy nem tartalmazott néhány érzékelőt, de az összes benne volt, Futtatás Fiament és Auto-Leveling. A nyomtatott kézikönyvben van néhány hiba. De a digitális helyes. Jó termék.