Minden üzenet

Raymondo1965 14/11/2021
This is an extremely powerful torch for its size and is a great product. I am using a 26650 Li-ion 5000mAh 3.7v battery, which brings the overall weight in at 383 grams. The torch came well packaged with clear and reasonably detailed instructions. It feels quite balanced in your hand when you are using it. The torch also comes with some adaptors in the battery compartment to suit different size batteries you might be using. I have the largest battery that will fit so did not need to use the adaptor. It will also take 18650 and 21700 3.7v batteries. Out of the box the torch is easy to use. Click once to turn it on and then you can click and hold the button to adjust the brightness. The first time you click and hold it will increase in brightness until you release the button. The second time it will decrease. There are a number of different modes that you can put this torch into including Strobe modes – Ramping modes – Utility modes and Muggle mode to name a few. Some of the strobe modes seem a bit gimmicky to me, like Lightning mode that simulates lightning strikes during a storm (don’t know when I would want to use this mode). It does have a Bike Flasher mode that will run at a medium level and then flash at a brighter level every second. With the power and brightness of this torch you will be able to be seen from a long way away. One of the more useful features is the Utility mode. This allows you to check the battery voltage and temperature using the light on the torch. In Voltage mode the light will blink to show the current state of the battery. The light blinks the whole number first and then a short pause before it blinks the tenths of volts next. It does have low voltage protection and high temperature protection built into the torch as well. This is a very good product with a very powerful beam of light. It does have some features that I think are gimmicky and wont be used, but overall it is a great torch and great value.
2
Ajánlások
Hozzászólások (0)

Raymondo1965 4in1is a multi protocol system. It will let the transmitter bind to different brands of receivers. From what I understand the ELRS is for long range transmission as well but you need receivers that will work. If you get the 4in1 you can use your old receivers if you have them and you can always add in the ELRS module later as it will plug into the space on the back of the transmitter

2022-07-03 10:21:05 Hasznos (0)
Beküldés
Válaszok (1)

Q: até dia 12 de julho vai ser enviado o pedido ?

Kérdezte BG184843912 tovább 2022-06-30 06:52:03

Raymondo1965 Mytransmitter was ordered on the 21-6-2022 and has now been sent on 2-7-2022. It was on backorder for a while.

2022-07-03 10:17:07 Hasznos (0)
Beküldés
Válaszok (1)

Q: would this fit into the wltoys wl916 speed boat?

Kérdezte BG133942352 tovább 2022-05-08 04:57:34

Raymondo1965 Iam not sure about the RC Speedboats but this battery has a triangular shape to it. The dimensions are 36mm x 36mm x 70mm. So if it will fit into your boat then it should be ok.

2022-05-12 12:32:41 Hasznos (0)
Beküldés
Válaszok (1)

Raymondo1965 Aslong as the connector is an XT60 and it can fit a battery with the dimensions of 25 x 34 x 135mm then it should be fine.

2022-05-12 12:31:06 Hasznos (0)
Beküldés
Válaszok (1)

Q: will it support flysky i6?

Kérdezte Mefaizsaiyad tovább 2018-03-18 08:28:52

Raymondo1965 Yesit does. I have a couple of them that I use with the flysky i6

2022-02-09 05:32:33 Hasznos (0)
Beküldés
Válaszok (2)

Q: Hi! is it works with eachine novice IV and tinyhawk freestyle II? thanks!

Kérdezte michiakj tovább 2022-02-03 03:29:58

Raymondo1965 It should work fine with the drones you are talking about. The signal they out out should be in the frequency range and the picture will be displayed and recorded by this device.

2022-02-03 03:47:39 Hasznos (1)
Beküldés
Válaszok (2)

Q: Original flysky Fs-i6??

Kérdezte Desanonimados tovább 2017-12-07 09:22:49

Raymondo1965 As far as I can tell it is the original receiver. This one is the Fs-iA6B which has the exta sBus and PWM outputs as compared to the standard Fs-i6A which only has the standard 6 channel outputs.

2022-01-30 02:45:01 Hasznos (0)
Beküldés
Válaszok (3)

Q: i need a spinner, what spinner fits?

Kérdezte schrotte9 tovább 2021-11-17 09:11:31

Raymondo1965 Theoverall spinner width is 59mm. You need to measure the shaft diameter of the motor you are using to make sure you get one that will fit your motor. Most of my motors have a shaft diameter of 3.17mm

2022-01-19 05:17:13 Hasznos (0)
Beküldés
Válaszok (1)

Raymondo1965 Ihavent tried it that way. The inputs are into the coloured RCA plugs and the output is the USB connector. If the XBox 360has RCA output connectors on it then there is no reason that would not work.

2022-01-19 04:56:53 Hasznos (0)
Beküldés
Válaszok (1)