ShadeyB
- Tartalom
- Minden üzenet
- Vélemények
- Hozzászólások
- Válaszok
- Kérdések
Válaszok
ShadeyB It’s a spare 0.4 nozzle
Hasznos (1)
ShadeyB Come’s with 0.4mm nozzle which are standard for printer. Pack of 25 replacement nozzles can be bought for £6 or less
Hasznos (1)
ShadeyB This works fine without any upgrades, I would suggest upgrading the bed levelling springs, this reduces the amount of times you need to level the print bed
Hasznos (0)
Q: whats the different between cw /ccw? thanks
Kérdezte Wolfgang Ahrer tovább 2020-10-12 13:34:43
ShadeyB Cwclockwise direction or ccw counter clockwise, I choose depending on directional spin on motor or if building twin engine be sure to have both to cancel out torque roll
Hasznos (1)
Q: support FRSKY D8 with PWM output?
Kérdezte haryosukoco tovább 2020-09-29 12:24:05
ShadeyB Yes to all your outputs, from Tx to Rx then into the A3 gyro which is linked to your control surfaces
Hasznos (0)
Q: will this work with Spektrum 11x transmitter?
Kérdezte BG188231212 tovább 2020-07-29 05:33:30
ShadeyB Yeahthis just transfers your TX-RX signals to the control surfaces with additional stabilisation input
Hasznos (1)
ShadeyB Yesit should be fine, your radio and receiver deals with your inputs , these are passed to the gyro which activates your control surfaces with stabilisation
Hasznos (1)
ShadeyB 220x220x250mm 220 length and width with 250 height
Hasznos (0)