RS2VN
- Tartalom
- Minden üzenet
- Vélemények
- Hozzászólások
- Válaszok
- Kérdések
Válaszok
Q: what is the total width of the three cables toghether? thank you
Kérdezte niconico tovább 2021-09-25 02:14:38
RS2VN when 230 is visible means that you have chosen 230V input
Hasznos (0)
Q: What wire gauge should I use for the battery connector and the ESC connector?
Kérdezte Christian Schneider tovább 2020-11-05 10:14:03
RS2VN Depends on the ESC and battery C. To be on the safe side use the same as it is on the ESC. If there is none, 14 AWG would be OK in most cases.
Hasznos (0)
RS2VN basically UART 3 is vacant and should work. I suggest that you follow the schematics and connect crossfire to UART 6. Use UART 3 for VTX (smart audio or IRC Trump).
Hasznos (0)
Q: can i know how to wire it? i burned already an FC.
Kérdezte Gianluca Puntara tovább 2019-03-03 05:31:00
RS2VN GNDto GND (FC), 5V to 5V (FC), PB- to B- (FC), Din to LED (FC)
Hasznos (0)
Q: am I correct in saying this firmware is FuryF4OSD (Diat)?
Kérdezte mariomazzanti23 tovább 2020-02-06 05:57:09
RS2VN Yes.But I have switched back to legacy (3.5) since 4.1 behaved creasy.
Hasznos (0)
RS2VN cca 3.7 mm
Hasznos (0)