v8rick
- Tartalom
- Minden üzenet
- Vélemények
- Hozzászólások
- Válaszok
- Kérdések
Válaszok
Q: Hi.. What sizes are the shanks on these and are they upcut spiral? Thank you
Kérdezte BG441381137 tovább 2022-05-21 13:35:55
v8rick shank same size as cutter , see table in description
Hasznos (0)
v8rick Not used for that. Use some one handed ratchet clamps cheaper and available everywhere. most are reversable clamp or separate
Hasznos (1)
v8rick Zero anywhere you like. I use this as bench not level so I can set on saw then check blade
Hasznos (0)
Q: what size dog hole will these clamps fit?
Kérdezte maxvacchio tovább 2019-06-17 07:33:34
v8rick standard20mm holes
Hasznos (0)
v8rick No just base Base. I attach using base then zero device
Hasznos (0)
Q: Hi, can this fit the smaller T track
Kérdezte BG453744502 tovább 2021-06-15 22:27:20
v8rick You would have to replace bolts on adjuster with T bolts there are 4
Hasznos (0)
Q: Where can I find slot nut for this Track?
Kérdezte Ábraham Péter tovább 2021-12-06 05:02:02
v8rick I use the 6mm and 8 mm T bolts that came with clamps off here. DrillPro Aluminium Alloy T-Track Hold Down Clamp with Slider Woodworking Tool
Hasznos (0)
v8rick Youjust get the center part ( camera not the outer IR parts
Hasznos (0)