Minden üzenet

Q: will this heater work with an afterburner controller

Kérdezte BG501141750 tovább 2023-11-28 09:15:56

BG203725422 I believe that the Bluetooth controller and its mainboard are shown as not compatible with the afterburner controller. If you refer to the afterburner website they list which controllers are compatible and which are not compatible

2023-12-04 02:20:01 Hasznos (0)
Beküldés
Válaszok (1)

Q: Is this "Carborundum" coated glass?

Kérdezte RENOxDECEPTION tovább 2021-04-26 05:29:34

BG203725422 Not sure about the carborundum glass, but I have 4 of these glass beds and use the un-coated side with a bed adhesive, gives very nice smooth finish to the parts. Let the glass bed fully cool down or I even put it my freezer before removing the prints, mostly they just pop off and because the glass provides a tough surface you don’t get damage if z-height offset is a little off.

2022-06-14 01:25:16 Hasznos (0)
Beküldés
Válaszok (2)

BG203725422 Newer Creality printers come with press fit gears on the extruder stepper motors and are a pain to remove, but you can achieve this and the original motor will work fine. If you want a direct drive unit this should work but mounts will need to be purchased or printed to convert.

2022-06-14 01:21:14 Hasznos (0)
Beküldés
Válaszok (3)

Q: Will this allow for printing with flexible filament?

Kérdezte bmack tovább 2020-09-30 10:58:14

BG203725422 You can print tpu easier with dual gear extruder, but you must adjust z-height adjustment and slow print speed to get any success, don’t go too soft as jams and retraction become serious issues

2022-06-14 01:17:08 Hasznos (0)
Beküldés
Válaszok (5)

Q: will it fit ender 3 v2?

Kérdezte simon tovább 2021-01-16 03:45:22

BG203725422 Yes, you may need new stepper motor as Creality push fit extruder gears and you also need to adjust e-step values

2022-05-30 11:58:44 Hasznos (0)
Beküldés
Válaszok (2)

Q: Does it fit Ender-3 V2? Thanks

Kérdezte BG651411359 tovább 2020-12-26 02:39:57

BG203725422 Yes, but remember you may need a new stepper motor as Creality use push fit gears and adjust your e-step values

2022-05-30 11:57:46 Hasznos (0)
Beküldés
Válaszok (3)

Q: will it work for ender 7?

Kérdezte liebendan tovább 2021-08-29 01:02:56

BG203725422 I don’t know sorry

2022-05-30 11:56:53 Hasznos (0)
Beküldés
Válaszok (3)