Minden üzenet

Q: does the motor have 2 poles or 4 poles?

Kérdezte Alian tovább 2021-10-17 12:28:42

The seller Hi,this f540 brushless motor is 4 poles

2021-10-18 05:29:22 Hasznos (3)
Beküldés
Válaszok (4)

Q: what are the benefits of each tail?

Kérdezte Alian tovább 2022-02-23 01:12:34

Nincompoop The conventional layout of T-tail is more stable, and the structure of v-tail is simpler and more flexible.

2022-02-24 03:58:38 Hasznos (1)
Beküldés
Válaszok (1)

Q: Can I use a 2s lipo battery in this car?

Kérdezte BG082137461 tovább 2021-07-02 01:56:39

Alian yes

2021-10-13 09:07:29 Hasznos (0)
Beküldés
Válaszok (2)

Q: what is the size of the motors?

Kérdezte Alian tovább 2020-04-15 03:13:44

BG204249554 little but they are still strong enough

2021-09-25 12:08:46 Hasznos (0)
Beküldés
Válaszok (2)

Q: will this work with Eachine EO16H?

Kérdezte Alian tovább 2021-06-08 06:04:42

Septimal Can not find Eachine EO16CH on BG Website, so can not make sure what procotol is it. iF8 support D8 / D16 v1 FCC / D16 v1 LBT / D16 v2 FCC / D16 v2 LBT (No Frsky ACCESS support) . You can check by yourself.

2021-06-11 04:55:49 Hasznos (0)
Beküldés
Válaszok (1)

Q: will this fit 12428?

Kérdezte Alian tovább 2021-03-28 12:58:09

Hoydenism No,you should buy this one drive shaft,product id is 1318141

2021-03-29 05:51:17 Hasznos (0)
Beküldés
Válaszok (1)

Q: what drone is that?

Kérdezte Alian tovább 2020-12-22 12:58:59

CutiePie not sure

2021-01-06 02:54:25 Hasznos (0)
Beküldés
Válaszok (1)

Q: Will this fit the Caddx Vista?

Kérdezte Alian tovább 2020-05-04 01:20:10

Winnit No, the Vista will not fit into this frame.

2020-05-05 09:01:11 Hasznos (0)
Beküldés
Válaszok (1)

Povd It is just a piece of wire but that is typical with any whoop board with a built in reciever and I'm sure it has something to do with them being synonyms for having horrible reception, that being said the antenna dosen't need to be grounded to work correctly. When you run ground to a receiver wire it's to ground the shielding on that wire and then the actual signal wire runs through the shielding till it getd close to the end where its exposed and this exposed wire at the end is what actually dose the work cause its cut to a certain length to work with the particular frequency being used 2.4ghz in this case. As long as that wire is the same length as the wire that exposed from the shielding on a wire that's has to be grounded it essentially dose the same job. but it also has to be free from obstructions cuase that can dramatically reduce your range so this is where longer shielded wires that have to be grounded are preferred if weight isn't an issue because they move the signal wire farther away from the obstructions of the frame and other parts on a model

2020-01-17 02:30:08 Hasznos (1)
Beküldés
Válaszok (1)