Andrew1978
Q: I wonder what prevented to make the size 15х24х8? Real size 15.86 x 25.8 x 8.1 mm
Kérdezte Andrew1978 tovább 2018-10-24 07:29:27
Jerry Fit for 8mm shaft
2018-11-04 09:51:45 Hasznos (0)
Q: Planet CNC? What about soft?
Kérdezte Andrew1978 tovább 2018-03-22 12:51:39
BogumMatt Sorry I don't understand what do you mean.
2018-03-26 09:28:26 Hasznos (0)
Andrew1978 how many lumens per strip?????????
2017-11-23 02:37:51 Hasznos (0)Őszintén meghívjuk Önt, hogy iratkozzon fel a Meghívó Válasz e-mailre!
Ha feliratkozik, e-mailben meghívjuk Önt, hogy válaszoljon az embereknek a termékekkel kapcsolatos kérdéseire. Ha feliratkozol, megkapod a "Hasznos jelvényt " is! Az adatvédelmi beállítások oldalon bármikor leiratkozhat.
Segíts másoknak, és légy boldogabb!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
Kworsfold From what I am reading (yet to be proven) but leaving these three microstep selection pins (MS1, MS2 and MS3) disconnected results in full-step mode pulling low (as per the track on the PCB) would result in Single step. As for Direction and Enable these are ACTIVE LOW.......... i.e. LOW to Enable and not reversed (reversed motor could be wiring or mechanical issues)
2019-03-20 10:51:00 Hasznos (0)