Minden üzenet

Chitarrone If there is no problem with battery power, try restoring the flashlight to factory settings. Anduril UI factory reset operation: first open the tail cap to power off, and then re-tighten the tail cap while holding down the switch. At this time, the flashlight will flash, and the flashing stops and the factory settings have been restored.

2022-07-02 02:54:35 Hasznos (0)
Beküldés
Válaszok (1)

Q: battery included or not?

Kérdezte mp1947 tovább 2022-05-31 02:51:01

djuricic.milan Read description, man. "Built-in 16340 battery with capacity of 1200mAh needs to be bought separately", in both cases, regardless of the size of battery tube. Also, don't forget that this light uses an "imported p100 wick", in other words this LED of unknown manufacturer is supposed to be high quality because it's "imported". Unfortunately, I also like this light, I am thinking of buying one just to use this host. If the battery is included, it's probably crap, just like this "p100 imported whatever", but the host looks nice in comparison with similar pocket zoomies, and it looks like the lens is retracted deep enough in the head, so, there shouldn't be that ugly ring effect. This host can probably be modded into a decent light. I wish they included glass plano-convex lens instead of the high quality imported led and the possibility of battery being present.

2022-06-01 04:08:52 Hasznos (4)
Beküldés
Válaszok (4)

hexfets The question was ; What is the manufacturer of this led?

2022-05-10 06:02:24 Hasznos (1)
Beküldés
Válaszok (2)

djuricic.milan Almost every 18650 laser pointer has 100-300mw radiant flux. They can be found for 4-6$, or something like 8$ with usb charging and installed low capacity 18650.

2022-04-20 02:36:56 Hasznos (0)
Beküldés
Válaszok (2)

Coops You need to supply it with ripple-free DC. So, not just a Rectifier... You also need smoothing capacitors to remove the 100-120 Hz half-sinusoidal pulses from the rectified mains. There are some capacitors on the input of this module, but they aren't intended to provide all the smoothing for a bridge rectifier. The constant voltage section will resolve any variations in input voltage so the transformer does not need to have perfect voltage regulation under load.

2021-01-15 04:23:37 Hasznos (0)
Beküldés
Válaszok (2)