Filek
Filek No! It will lower the 14.4 volts to 12v, but it will NOT raise the 10.5v up to 12v
2022-02-25 07:28:57 Hasznos (1)Q: Can I plug this directly into the ender 3 or do I need to change the firmware?
Kérdezte Meebert tovább 2020-08-18 05:32:40
Filek It doesn’t fit in the stock Ender 3 pro heater block
2022-01-30 07:18:54 Hasznos (0)
Filek The Ender 3 pro has the same Bowden tube setup, with same hot end and extruded and would have the same difficulty printing TPU as regular Ender 3
2021-12-05 06:17:13 Hasznos (0)
Filek Yes, it would work, but I would keep the glue to the screen edges. The glues is clear, but might have a slight cloudiness. A much better glue would be the UV cured resin for screen repair.
2021-12-05 06:14:23 Hasznos (0)
Őszintén meghívjuk Önt, hogy iratkozzon fel a Meghívó Válasz e-mailre!
Ha feliratkozik, e-mailben meghívjuk Önt, hogy válaszoljon az embereknek a termékekkel kapcsolatos kérdéseire. Ha feliratkozol, megkapod a "Hasznos jelvényt " is! Az adatvédelmi beállítások oldalon bármikor leiratkozhat.
Segíts másoknak, és légy boldogabb!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
BG245618134 contact the customer support.
2022-04-11 06:28:40 Hasznos (1)