Ronaldsneek
Q: Can you reset the minimum maximum or is it per day and does it reset itself?
Kérdezte Ronaldsneek tovább 2018-08-10 03:01:27
marcar They should work fine with at least 3 V, probably very dimm or no light at all at 2.4 V (specifications: Forward Voltage:3.05-3.65V (250mA))Powering it with AAA batteries will not last much due to demanded current. Apart from this, when batteries discharge a bit, you will be below 3 V.Maybe a 18650 LiPo battery with higher capacity is a better option.
2020-02-17 08:57:48 Hasznos (0)
Dario NONARRIVATO.QUANDO ARRIVERA'?
2019-06-29 04:48:28 Hasznos (0)Q: can you show the bottom side?
Kérdezte Ronaldsneek tovább 2019-05-03 01:11:50
lmml Sir youcan aks them to take an photo of this product for you :https://www.banggood.com/Contact-Us_hi111
2019-05-08 06:51:45 Hasznos (0)
Ronaldsneek If temperature is reached unit turns the heater off, If temerature is below the programmed temperature it will turn the heater on again. It is not self modumating, that happens only if the thermostat and the heater are from the same brand.
2019-01-07 05:03:09 Hasznos (1)Q: In Dutch it says "muffler pipe" do you get the muffler or also the pipe? Thanks!
Kérdezte Ronaldsneek tovább 2019-01-01 09:33:53Q: Will 13 or 14,5 Volt break the pir? for car use the dynamo is 14,5 Volt when charging.
Kérdezte Ronaldsneek tovább 2018-12-26 02:03:58
Hist Working voltage: DC 2.7-12V，it can't exceed 12V
2018-12-31 12:20:23 Hasznos (0)Q: Is the switch for turning off the light of the Voltmeter or the USB plug? Or both?
Kérdezte Ronaldsneek tovább 2018-12-21 03:40:25
Happypear both
2019-01-04 07:13:00 Hasznos (0)Q: Is it possible to switch the fan on and off with this product?
Kérdezte Ronaldsneek tovább 2018-08-25 06:38:18
Ogive you can try that
2018-08-31 04:59:37 Hasznos (0)
Lamella 9*6*4cm
2018-08-31 04:36:34 Hasznos (0)
Ronaldsneek Thank you very much.
2018-08-16 05:15:30 Hasznos (0)
Ronaldsneek Do you have it direct to a solar panel or via a solar panel controller?
Őszintén meghívjuk Önt, hogy iratkozzon fel a Meghívó Válasz e-mailre!
Ha feliratkozik, e-mailben meghívjuk Önt, hogy válaszoljon az embereknek a termékekkel kapcsolatos kérdéseire. Ha feliratkozol, megkapod a "Hasznos jelvényt " is! Az adatvédelmi beállítások oldalon bármikor leiratkozhat.
Segíts másoknak, és légy boldogabb!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
.JPG)
Franson Pressing and holding the C/F key will reset the high/low readings. Else it will reset automatically every 24 hours (from time when batteries were inserted or from time the C/F key was pressed/held).
2019-12-30 04:56:01 Hasznos (4)