Minden üzenet

Madav65 Out of the box these are extremely nose light. Try adding some weight to the nose to trim it properly.

2022-08-10 12:47:03 Hasznos (0)
Beküldés
Válaszok (1)

Q: How can i connect ibus to the controller?

Kérdezte BG244611121 tovább 2022-08-08 06:39:57

Madav65 You have to connect your ibus receiver to a RX pad on the flight control board. Then set the receiver type to Ibus in Betaflight.

2022-08-10 12:44:30 Hasznos (0)
Beküldés
Válaszok (1)

Madav65 A 50mm ducted fan unit with brushless motor. 3s compatible. 4300kv motor. Buy it as a complete unit. Two sg90 or similar servos A receiver to suit your transmitter. A 30amp esc. ( I would recommend a Hobbywing) A 3s lipo battery. 1500mah seems a good size for these.

2022-07-15 12:53:11 Hasznos (0)
Beküldés
Válaszok (1)

Q: can I connect a eachine vtx03 to the e10?

Kérdezte Joey351 tovább 2019-10-07 09:29:27

Madav65 You can fit a small fpv camera to most of these small drones. keep it as central and as light as possible

2022-07-15 12:44:48 Hasznos (0)
Beküldés
Válaszok (3)

Q: IS A CELL PHONE NECISSARY?

Kérdezte BG153681010 tovább 2022-07-13 03:18:50

Madav65 Yes, the GPS will not work correctly and you won't be able to use the camera without a phone

2022-07-15 12:41:10 Hasznos (0)
Beküldés
Válaszok (1)
Madav65 09/10/2021
A nicely finished little model with more scale detail than the Mustang or Trojan. I already own both of these and I guess I was expecting a similar flying experience from this model. Unfortunately out of the box this is extremely nose light . I'm still working on the optimum Cg position but pushing the battery as far forward as possible and a second battery pushed in behind to act as ballast has greatly improved it. I will probably try a larger battery rather than just carrying deadweight, there is ample room for this. As supplied there is a massive amount of down trim on the ailerons, If this was intentional it makes the nose light issue even worse. I reset mine to a neutral position. Flight tests so far are much improved with the more forward Cg and the control surfaces set correctly. Keep the speed up in turns as it will drop a wing if slowed down too much. Make sure that you use the small headed screws to attach the tailplane. These fit inside the fueselage properly to allow correct attachment. This model has lots of potential and will be fine once trimmed out correctly. Sadly it is just not as well sorted as the previous warbirds, which are a pleasure to fly straight out of the box. Beginners will be better off starting with one of these as the P47 needs more work to get it to fly well. If I can work out what RC protocol this uses I will try binding it to my Jumper transmitter. This model really needs some expo setting up to allow it to fly to its full potential. Unfortunately it doesn't seem to use the same one as the Mustang and Trojan , which both benefited from a 40% expo setting on ailerons and elevator.
13
Ajánlások
Hozzászólások (11)

Q: Which FPV goggles can I use with it?

Kérdezte BG311361833 tovább 2022-06-04 03:13:03

Madav65 Youcan't use fpv goggles with this, the video is transmitted by WiFi, only works with a phone that supports 5.8Ghz WiFi

2022-06-23 08:20:30 Hasznos (0)
Beküldés
Válaszok (2)

Q: Can i fly this with my flysky fs-i6x?

Kérdezte Patrick tovább 2022-05-25 07:20:57

Madav65 Yes , that's what I use for mine. Fli14 receiver fits in ok too.

2022-06-01 03:17:13 Hasznos (0)
Beküldés
Válaszok (1)

Madav65@bikinidan I suspect you are correct on the manufacturer. Thanks for the info. on the protocol, I\'ll have a go at binding my Jumper Tx to it.

Madav65 09/10/2021
A nicely finished little model with more scale detail than the Mustang or Trojan. I already own both of these and I guess I was expecting a similar flying experience from this model. Unfortunately out of the box this is extremely nose light . I'm still working on the optimum Cg position but pushing the battery as far forward as possible and a second battery pushed in behind to act as ballast has greatly improved it. I will probably try a larger battery rather than just carrying deadweight, there is ample room for this. As supplied there is a massive amount of down trim on the ailerons, If this was intentional it makes the nose light issue even worse. I reset mine to a neutral position. Flight tests so far are much improved with the more forward Cg and the control surfaces set correctly. Keep the speed up in turns as it will drop a wing if slowed down too much. Make sure that you use the small headed screws to attach the tailplane. These fit inside the fueselage properly to allow correct attachment. This model has lots of potential and will be fine once trimmed out correctly. Sadly it is just not as well sorted as the previous warbirds, which are a pleasure to fly straight out of the box. Beginners will be better off starting with one of these as the P47 needs more work to get it to fly well. If I can work out what RC protocol this uses I will try binding it to my Jumper transmitter. This model really needs some expo setting up to allow it to fly to its full potential. Unfortunately it doesn't seem to use the same one as the Mustang and Trojan , which both benefited from a 40% expo setting on ailerons and elevator.
13
Hozzászólások (11)

Q: Kompatibel für bf 109 ?

Kérdezte BG475514332 tovább 2022-04-20 11:43:26

Madav65 yes, the same circuit board for all the mimi warbird series

2022-04-26 02:10:16 Hasznos (0)
Beküldés
Válaszok (1)