BG531555735
Alexanderman this is a common problem on most FDM printers. if the center is lower, you can try removing the spring steel sheet, puttting some painter's masking tape on the magnetic plate (right in the center) and then put the spring steel sheet back on. the tape might raise the center just enough. alternatively you can install a BLtouch/3dtouch
Alexanderman I see a question regarding thread size on these nozzles was answered as being M7? is that correct? as the B1 hotend accepts M6 threads, not M7? so which one is it?
2021-09-01 11:53:07 Hasznos (0)
Q: What size filament is needed for this printer
Kérdezte BG199381544 tovább 2021-07-03 09:13:02
Alexanderman standard this machine comes with a bowden setup for 1.75mm filament.
2021-08-23 11:57:19 Hasznos (0)
cmicheli346 hello, it is as you said, only that when you connect it to the board you have to be careful that it follows the same order, for example I had to invert 2 pins on the connector that goes to the board. As you say "g" "v" "s" but on my board I have "g" "s" "v" Nothing complicated, I work for 1 minute
2021-08-05 04:16:21 Hasznos (1)Őszintén meghívjuk Önt, hogy iratkozzon fel a Meghívó Válasz e-mailre!
Ha feliratkozik, e-mailben meghívjuk Önt, hogy válaszoljon az embereknek a termékekkel kapcsolatos kérdéseire. Ha feliratkozol, megkapod a "Hasznos jelvényt " is! Az adatvédelmi beállítások oldalon bármikor leiratkozhat.
Segíts másoknak, és légy boldogabb!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
Kekuj ok
2021-08-30 03:53:02 Hasznos (1)