Minden üzenet

Q: What is the max RF Power for this bridge?

Kérdezte BG172101915 tovább 2022-01-17 11:27:44

BG321646142 Documentation indicates 100 W

2022-02-01 05:21:01 Hasznos (1)
Beküldés
Válaszok (2)

Q: Is this chip genuine FTDI or clone?

Kérdezte BG172101915 tovább 2021-02-07 10:52:48

WolfxPac how do you differentiate between them? it's open-source hardware using same USB to TTL IC.

2021-09-17 12:19:16 Hasznos (0)
Beküldés
Válaszok (2)

Q: What is the measurement frequency for this unit?

Kérdezte BG172101915 tovább 2020-02-28 12:37:22

BG555247215 Thisdevice measures earth ground resistance, not the frequency

2020-11-05 01:14:14 Hasznos (0)
Beküldés
Válaszok (2)

Q: What is the diameter of

Kérdezte rbusque tovább 2018-03-28 07:10:50

PampaWak About8mm. Please permit me 1-3cm of tolerance because of manual measure.

2020-05-05 12:07:28 Hasznos (0)
Beküldés
Válaszok (1)

Q: What is the diameter of ceramic insulator protecting the wires?

Kérdezte rbusque tovább 2018-03-28 07:11:37

PampaWak Idon't know exactly, but it's about 8/10mm. Sorry for this delay, but I didn't know about this part of the website!

2019-10-18 04:55:37 Hasznos (0)
Beküldés
Válaszok (1)

Q: What is the diameter of the ceramic tube?

Kérdezte rbusque tovább 2018-03-28 07:14:18

Sandu max12.4mm, min 10.4 mm - is eliptic, not round

2019-09-17 09:25:32 Hasznos (0)
Beküldés
Válaszok (1)

Q: nela pode por 2 filamento ao mesmo tempo ?

Kérdezte ????????? tovább 2019-08-11 07:20:32

rbusque Natively,it can only handle one filament at a time. This being said, my impression is that these are highly modifiable.

2019-08-12 07:53:23 Hasznos (0)
Beküldés
Válaszok (4)

rbusque Minedid not have magnetic platform. When I researched the resume function for this, though possible, it was clear there would always be some artifact in the print...I opted to not enable it. Printing can be done directly from the micro SD. Extruder is nothing fancy. I ended up installing a bed sensor for levelling...made a huge difference in repeatability.

2019-08-12 07:50:56 Hasznos (0)
Beküldés
Válaszok (4)