aerophoto
aerophoto Auriez vous une grande photo permettant de positionner le connecteur de l'cran dans la bonne position ? Merci
aerophoto Have you a picture helping to put the display connector on the right position to be able to start the receiver ? Thanks.
aerophoto Have you a picture of your transmitter with the cables connected ? Thanks.
Lanny Hello, thanks for your sharing.
2018-09-07 03:25:14 Hasznos (1)
Imbueeeam I don't know
2018-01-11 01:11:26 Hasznos (0)Őszintén meghívjuk Önt, hogy iratkozzon fel a Meghívó Válasz e-mailre!
Ha feliratkozik, e-mailben meghívjuk Önt, hogy válaszoljon az embereknek a termékekkel kapcsolatos kérdéseire. Ha feliratkozol, megkapod a "Hasznos jelvényt " is! Az adatvédelmi beállítások oldalon bármikor leiratkozhat.
Segíts másoknak, és légy boldogabb!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
pksteffen Yes! Thank you. Pull out slightly the two black tabs at the bottom where the ribbon cable goes into the board. They will slide a small amount out towards the edge of the board. This allows you to insert the ribbon cable into the slot and then push the two tabs and bottom piece back in to secure the cable to the board!
2019-08-08 04:04:35 Hasznos (0)