Minden üzenet

JonathonKeen I just installed it into a retro Yamaha natural sound CR - 420. I used an old phone charger that had 5-volt out and wired it to the fused switched power at the main board. then I ran the outputs from the Bluetooth board to the tape in inputs behind the rear panel. I'm impressed with the sound quality but it clicks very loudly between songs on my playlist. my other Bluetooth boards do not do this

2019-05-11 09:48:05 Hasznos (0)
Beküldés
Válaszok (1)

Q: 4 ohm output?

Kérdezte JonathonKeen tovább 2019-04-14 08:09:43

wujiahui yeah,this is 4 ohm.

2019-04-14 08:19:33 Hasznos (0)
Beküldés
Válaszok (1)

Q: can I use these as actual teeth?

Kérdezte JonathonKeen tovább 2019-02-08 08:27:59

jinbao No, this is acrylic braces.

2019-03-01 03:26:12 Hasznos (0)
Beküldés
Válaszok (1)