Minden üzenet

Q: Is 5v pin output or input ?

Kérdezte Dhrumil tovább 2018-12-28 06:16:48

Kahikatea https://img.staticbg.com/images/oaupload/banggood/images/4E/38/202a38e8-7330-4f41-81d1-f7df4ba3146f.jpg

2019-01-04 03:47:03 Hasznos (2)
Beküldés
Válaszok (2)

polypagan esp32 has 2 adc's each of which has an analog mux on input (like Uno). this board had 6 analog input in usual location. on digital side, pins go rxd, txd, gpio26 (dac2), 25 (dac1), 17, 16, 27, 14, then 12, 13, 5, 23, 19, 18. followed by gnd, rst, sda, scl.

2019-09-09 01:03:45 Hasznos (2)
Beküldés
Válaszok (3)

holdenweb Any wall wart should do - the Mini needs less than a fifth of an Amp as I recall. It regulates the 5v from the wall wart down to 3v3 to drive the ESP8266, so digital interface logic should operate at 3v3 unless you want to use level converters. The analogue input pin A0 won't tolerate more than 3.2v so treat it gently.

2019-05-29 02:39:39 Hasznos (1)
Beküldés
Válaszok (2)

Q: can you give power supply product link ? where to buy ?

Kérdezte Dhrumil tovább 2018-07-28 12:37:23

Karmen Maybe you can find it in "Electronics-Arduino Compatible SCM&DIY Kits" Category.

2018-08-01 08:13:22 Hasznos (0)
Beküldés
Válaszok (1)