Cartho
Cartho You have to loosen the 3 screws holding the motorpackage to the plate. Taket a square and align with the sawblade/sawtrack. Tighten the 3 screws again and the saw will work perfect. Perhaps the belt has some slack too, then you loosen the 2 screws on the motor and turn the motor until the beltslack is gone. Tighten the 2 motorscrews and you are done. Precaution!! Never work on the saw with electric cable connected! Allways take the cable out before screwing on the saw. (You might by mistake press the switch and the blade could start spinning)
Őszintén meghívjuk Önt, hogy iratkozzon fel a Meghívó Válasz e-mailre!
Ha feliratkozik, e-mailben meghívjuk Önt, hogy válaszoljon az embereknek a termékekkel kapcsolatos kérdéseire. Ha feliratkozol, megkapod a "Hasznos jelvényt " is! Az adatvédelmi beállítások oldalon bármikor leiratkozhat.
Segíts másoknak, és légy boldogabb!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
