belair_boy
belair_boy My unit came with a brass, 0.4 mm diameter nozzle
2021-10-24 03:46:15 Hasznos (0)
Lyoid The camera angle is 170 degrees actually .
2020-01-06 03:41:53 Hasznos (0)
XENUSIS1 non c est du 120 , je vais faire une réclamation pour cela !
2018-06-26 06:47:26 Hasznos (0)
Őszintén meghívjuk Önt, hogy iratkozzon fel a Meghívó Válasz e-mailre!
Ha feliratkozik, e-mailben meghívjuk Önt, hogy válaszoljon az embereknek a termékekkel kapcsolatos kérdéseire. Ha feliratkozol, megkapod a "Hasznos jelvényt " is! Az adatvédelmi beállítások oldalon bármikor leiratkozhat.
Segíts másoknak, és légy boldogabb!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
belair_boy I tried to print a benchy in ABS several times and was not able to get it to stay stuck to the bed. Even with the heated bed, shrinking of the ABS as it cools caused it to warp and pull off the bed. Even with a brim it only was able to print several layers until it became detached. I even tried hairspray to help with adhesion but it didn't work. Maybe a heated chamber or a shield to prevent the hot end cooling fan from affecting the print would work but it didn't work out of the box for me.
2021-10-24 03:53:50 Hasznos (0)