gipsyblues
Q: Is this listing for version1 or version2?
Kérdezte gipsyblues tovább 2019-12-05 17:28:08
Q: WHAT IS THE PIN OUT DESCRIPTION OF THE YELLOW 8 PIN BLOCK ON THIS BOARD?
Kérdezte gipsyblues tovább 2020-01-03 16:17:58
Creat the pinout fits directly onto an ESP-01 or ESP-01s, it's just plugged in there. Add power (5V) to this board, and the ESP also gets the power it needs (3.3v, regulator is on this board). Ignore the an... Többet látni
2021-11-01 15:36:18 Hasznos (0)Q: what battery is suggested for use with this device? Is it for internal or external use
Kérdezte gipsyblues tovább 2021-04-03 21:08:42
Yogurt Use a lithium battery, which can be placed inside the case, but note that the battery size should be smaller than the case size
2021-04-08 02:09:20 Hasznos (0)
Lupar https://github.com/Xinyuan-LilyGO/LilyGO-T-Beam
2020-03-03 02:12:33 Hasznos (1)Q: I asked the following question earlier and did get an answer from Lupar: Could anybody share which demo programme, including URL of the code which allows the TTGO T-Beam v1.0 to blink (flash) the builtin LED?? I just can't get the T-Beam v1.0 to blink . Unfortunately Lupar's URL did not lead to the arduino file which has the Blue LED (battery charging / battery level status) blinking code. My question Többet látni
Kérdezte gipsyblues tovább 2020-03-03 12:57:02
sam1301 I’m not sure there is a blink sketch to blink the blue LED as it’s actually linked to the AXP charge chip and not the ESP32 chip. It may be possible if you can instruct the AXP chip to turn on and of... Többet látni
2020-03-22 15:02:40 Hasznos (0)Q: what thread type is this nozzle, I am looking for an NPT thread type
Kérdezte gipsyblues tovább 2019-09-23 19:12:25
Bakulesh this one is not NPT thread type. it is straight one
2019-09-24 01:04:52 Hasznos (0)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you’ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
dmeagor I needed to use the V1 board settings to get it to upload in Arduino IDE so I'm guessing its V1.
2020-06-01 17:16:25 Hasznos (0)