DUE R3 32 Bit ARM modulfejlesztő lap USB kábellel a Geekcreit cégnek az Arduino támogatásával - termékek, amelyek az Arduino hivatalos lapokkal működnek

Kapcsolódó vélemények

• Által tao13 10/02/2014 I bought again and again from here. Perfect quality and shippment. This arduino is a perfect image of original one and it works in the same good parameter and good condition.After 12 hours of work it remaining upstairs without heat cpu or otherelse. Good quality of soldering and pins. NICE WORK. GREATE SELLER!
• Által rear29 03/04/2014 This is a very cheap Arduino Due Clone. Unfortunately my board do not work out of the box. After some research i find out, that in the position of C20, an 0 ohm resistor was mounted instead of a 10 nf capacitor, and a second capacitor (C29) was soldered only on one side. The problem is easy detectable: There is a short between MASTER-RESET and 3.3 Volt. You may see the following problems: -- You can download a sketch, but it do not start. You can start the sketch by pressing reset. -- If a sketch